Manufacturer product imagery · configuration may vary
Reclaim Energy / Hot water
CO2 split systemReclaim CO2 heat pump
A split-system heat pump running on CO2, with the compressor outside and your choice of tank. Four tank families cover everything from a tight side passage to bore water.
Tank type
Tank size
Heat pump
Fully installed, including GST. That is the system, the standard changeover, both trades, the compliance certificates and removal of your old unit. What counts as standard is spelled out below.
WHAT THE PRICE COVERS
Installed, not just delivered.
Reclaim is a split system: one compressor outside, one tank, and the tank comes in four families. The buttons above only offer combinations Reclaim actually sells, so you cannot land on one that does not exist.
Included in a standard installation
- Supply and delivery of the complete system
- A licensed plumber and a licensed electrician, both trades included
- Removal and disposal of your old hot water unit and all packaging
- Reconnection to your existing water pipework, in the existing position
- Full valve set: isolation, non-return, pressure limiting, PTR and a tempering valve
- Reconnection to existing electrical cabling, with isolation switch and safety switch
- Plumbing compliance certificate and certificate of electrical safety
- Commissioning, timer set-up and a walk through of how to run it
- Warranty registration and all government certificate paperwork
- Up to 3 m of insulated copper between the compressor and the tank
What can add to it
None of these are hidden surprises. We look for every one of them before quoting, and if any apply you will see the cost in writing before anything is ordered.
- Moving the system to a new position, which means new pipe runs and often a new base
- A new dedicated circuit, or switchboard work where there is no spare way or no safety switch
- Moving off a controlled load tariff to continuous supply, where your retailer charges to do it
- A new concrete pad or pavers where the old base is undersized, unlevel or rotten
- Crane or difficult access: rooftop, courtyard-only entry, a steep block or a narrow side passage
- Asbestos in eaves, meter boards or wall sheeting, which needs a licensed removalist
- A condensate discharge point where there is no legal one within reach
- Gas decommissioning and meter removal if you are coming off gas
- An internal or upper-level tank, which needs a safe tray and a drain
- Pipe run beyond 3 m between compressor and tank, charged per metre of insulated copper
- A wall bracket or ground stand for the compressor where one is needed
So what counts as a standard job?
Your existing unit sits outside at ground level, on a sound base, somewhere we can reach without special access. The new system goes back in the same place, using the existing water pipework and a straightforward electrical run to the switchboard. Single storey, no asbestos, and no tariff change needed.
Your selected system
- Model codeThe code on your quote and your warranty registration
- SpecificationThe figures that decide whether it fits where the old one sat
- WarrantyDifferent parts of the system are covered for different lengths of time
- Refrigerant
- R744 carbon dioxide
- Compressor
- EHPE-4550P-A with Wi-Fi controller
- Frost protection
- Runs automatically when ambient and pipe temperature fall below 3 C
- Pipe run limit
- 10 m horizontal, 5 m vertical, maximum 4 bends
- Supply
- 240 V single phase on a dedicated circuit
- Tempering valve
- Mandatory, and included
The certificate discount shown is an estimate for Canberra's zone at the current certificate price, and it moves with the market. ACT and NSW each have their own rebates with their own eligibility rules, and the ActewAGL offer only applies if you are replacing a gas system. We confirm every figure that applies to your address, in writing, before anything is ordered.
THE PRODUCT, EXPLAINED
What matters in everyday use.
Keeps heating when the morning is below zero
Choose the tank that fits the space and the water
Compressor and tank can sit apart
Could it suit your home?
Canberra and Monaro households where winter mornings are genuinely cold, and any site where the tank cannot go exactly where the compressor needs to be.
Check before you choose
The pipe run between compressor and tank is limited to 10 m horizontal and 5 m vertical with no more than four bends. That is the single most common reason a job is not standard, so we measure it before quoting.
Confirm the exact Australian model, compatibility, installation location and warranty conditions in your final proposal.
THE DETAILS, IN ONE PLACE
Documents, photos & video.
Read the highlights here, then open the manufacturer documents for the detail.
Technical information
Reclaim heat pump and controller V2 specifications (Reclaim) ↗Warranty information
Model-specific documents are not yet linked.
Ask us for this document ↗Match the exact model code and Australian configuration to your proposal. Warranty coverage, conditions and exclusions are set out in the applicable manufacturer document.
What customers and the industry say
Don’t take our word for it.
289 reviews
4.8132
4.7157Recognised by the industry
- ★2026Local Solar Hero, ACTSunWiz Awards 2026
- #22026#2 Battery installer, ACTSunWiz Awards 2026
- #22026#2 Solar installer, ACTSunWiz Awards 2026
- #42024#4 Top-rated solar installers, CanberraSolarQuotes 2024
BACKED BY US, NOT JUST THE MANUFACTURER
A 1-year workmanship warranty on the installation, and the manufacturer’s warranty on the heat pump hot water system.
The manufacturer covers the heat pump hot water system itself. We cover our installation work: for 1 year from the date of installation, a defect that comes from our workmanship is put right by us — repaired, re-done, or the affected installation part replaced — at our cost and at our choice of remedy.
- It covers our work, not the product. A fault in the heat pump hot water system itself is a manufacturer warranty matter.
- Keep your rights. It adds to the Australian Consumer Law guarantees, never replaces them.
- What it does not cover: damage from misuse, changes or repairs by someone else, storms, surges and grid events, pests and corrosion, building movement, ordinary wear, and internet or monitoring problems. A call-out where no workmanship fault is found may be charged.
- To claim: email engineering@solar4life.com.au or call 1300 997 005 with your name, the installation address, what is wrong and photos. Tell us promptly; delay can affect a claim.
Residential installations. The full terms are in your installation agreement.
Specifications on this page are taken from Reclaim Energy’s published documentation for the Australian model. We confirm the exact model, how it works with your existing equipment and the current warranty terms before you accept a written quote.